Sydney Performance Parts & Tyres

Turbosmart Constant Tension Hose Clamps – 1.125" to 1.500" (29–38mm), Pack of 2 (TS-HCT-M033)

Turbosmart Constant Tension Hose Clamps – 1.125" to 1.500" (29–38mm), Pack of 2 (TS-HCT-M033)

SKU: TS-HCT-M033

AUD 39.99

In stock

Brand: Turbosmart

The Turbosmart Constant Tension Hose Clamp TS-HCT-M033 is a spring-loaded clamp for hose outside diameters from 1.125" to 1.500" (29–38mm), supplied as a pack of two. It is the smallest size in Turbosmart's constant tension range and suits small-bore silicone hose on breather, heater, coolant and turbo oil-drain lines.

Why constant tension?

Every time an engine heats up and cools down the hose and the pipe underneath expand and contract at different rates. A conventional worm-drive clamp is fixed at one diameter, so each heat cycle leaves it a little looser – which is why hoses that were tight when fitted start to seep or blow off months later. A constant tension clamp keeps a spring-loaded load on the hose at all times, taking up that movement so the joint stays sealed through thousands of heat cycles without re-tightening.

Turbosmart features

  • Convoluted dual spring-action outer band – maintains clamping load as the hose and pipe expand and contract.
  • Dual-bead inner shell – spreads the load evenly around the hose for a leak-free seal without a pressure point.
  • Flanged edges – protect the hose from being cut or damaged under load.
  • Fits a 5/16" socket or flat-blade screwdriver; tighten to 5.6 Nm (50 in-lb).
  • Sold as a pack of 2.

Typical uses

  • Breather and catch-can hoses
  • Heater and small coolant hoses
  • Turbo oil-drain and water-feed hoses
  • Small-bore silicone elbows and reducers

Suits Turbosmart silicone hose

Matches the outside diameter of Turbosmart's smaller silicone hose, including the 0.75" 45° elbow, 1.00" 90° elbow, 1.25" 45° elbow and 1.25" 90° elbow, plus the small end of the 1.25" to 1.75" reducer. Always measure the hose outside diameter (not the pipe) when choosing a clamp size.

Other sizes

247 Storefront is an authorised Turbosmart stockist. Ships from Sydney, Australia.

Part number
TS-HCT-M033
Brand
Turbosmart
Type
Constant tension hose clamp
Clamping range
1.125" – 1.500" (29 – 38mm)
Quantity
Pack of 2
Drive
5/16" socket or flat-blade screwdriver
Torque
5.6 Nm (50 in-lb)
Features
Convoluted dual spring-action outer band, dual-bead inner shell, flanged edges

Related products